Q:Vacuum Pump Buzzer alarm 1 Beep.

Reason:The main vacuum pump is damaged or negative pressure is adjusted too low or negative pressure meter parameters are modified.

Settlement:Replace the main vacuum pump or increase negative pressure or reset the parameters of negative pressure meter and reboot ink system.

Q:Vacuum Pump Buzzer alarm 2 Beep.

Reason:Negative pressure overrate.

Settlement:Adjust the negative pressure to the normal range of -3.8 or so（Vary in different areas）.

Q:Ink Pump Buzzer alarm 3 Beep.

Reason:Ink supply timeout.

Settlement:Settlement: Check the ink tank, if the ink is empty, fill it, otherwise there may be ink pump damage or leak .

Q:Communication Cable/Circuit Board Buzzer alarm 4 Beep.

Reason:Communication failure between external device control board and head board.

Settlement:Check the communication cable or replace the head board or external device control board.

Q:Communication Cable/Circuit Board Buzzer alarm 5 Beep.

Reason:The ink flows into the negative pressure box.

Settlement:Check if the negative pressure too high or the liquid sensor malfunctioned, clean or replace the air pipe, replace the ink pressure valve if infiltrated.

Q:Communication Cable/Circuit Board Buzzer alarm 6 Beep.

Reason:Ink tank staving.

Settlement:Locate the color and refill.

Q:UV lamp automatically extinguished, or the ink can not be cured while the light is unstable.

Reason:Filter cotton too dirty or the voltage is unstable or the lamp lifetime is over.

Settlement:Replace the filter cotton or check the power supply or change the lamp.

Q:UV Lamp Shutter The lamp shutter jammed causing the switch failure.

Reason:High temperature expansion jam.

Settlement:Check the causing of jamming and make mechanical modification.

Q:Two magnitudes rocker switch UV lights or fans can not open, joint burnt black.

Reason:Large current operation.

Settlement:Replace the rocker switch, ensure the connections are solid when replacing.

Q:￠4X2.4 Ink tube The negative pressure decrease and fluctuate when carriage running or the ink tube inside the chain leaks.

Reason:Crushed by the high-speed running of the chain.

Settlement:Replace the ink tube.

Q:External device control board, Error:"Communication with peripheral unit control board is failed!"

Reason:Computer case ungrounded, hot plugging communication cable or frequent shutdown.

Settlement:Replace the external device control board, make sure the machine and computer is off when operating the communication cable, at least 30 seconds between each on/off, solid grounding of the computer case is necessary.

Q:Photoelectric switch on the left base point Can't return to the base point on the left guide trail, photoelectric switch light keep lighting.

Reason:Origin switch is stained with ink, the light is blocked.

Settlement:Wipe clean with alcohol or replace.

Q:Computer crash, all software unavailable.

Reason:Virus.

Settlement:Anti-Virus, or record parameters of color registration, temperature and voltage, then reinstall the computer and software.

Q:Guide rail beam end cover Abnormal sound in the guide rail beam end cover.

Reason:Resonance.

Settlement:Adjust the tightness of the fixed screw.

Q:Almost every nozzle on the black ink print head presents serious inclined jet.

Reason:Black ink print head surface is easy to be cured.

Settlement:Use clean cloth with cleaner to clean the nozzle surface repeatedly until it's normal again.

Q:Negative pressure regulating valve The negative pressure is not stable, and sometimes automatically becomes higher or lower and cause dropping.

Reason:The dust in negative pressure control valve affected the air flow.

Settlement:Clean the negative pressure control valve every month.

Q:Data Transfer Card Error:"Can not find Data Transfer Card in the computer!\n".

Reason:The data transfer card is not plugged in or the driver is not installed correctly or the gold finger is dirty.

Settlement:Reinsert data transfer card or reinstall the driver or clean the gold finger.